PB-SW08-TP120

Feature

• Major ports: 1pcs 100Mbps uplink fiber port, 8pcs 100Mbps downlink Ethernet port , every port supports MDI/MDIX;
• Special function: One key CCTV mode; 1～8 downlink ports can only communicate with uplink ports;
• Power input: DC48V～57V;
• Transmission Distance: 0～100m; the furthest transmission distance could reach 250m in CCTV model; Uplink port can reach 100m;
• Standard: Meet IEEE802.3 、IEEE802.3u、IEEE802.3 af/at standards, PoE use End-Span, the spare cable can be of other use;
• Protection: Excellent anti-thunder, anti-static and anti-interference ability;
• Appearance: Delicate design and easy installation, configure the anti-theft lock hole, guard against theft;
• Operation: Plug and Play, No Setting required.

Notice!
The transmission distance is related to the connected cable. We suggest standard Cat5e/6 network cable, so the transmission distance can up to further distance!

Board Diagram

Notice!
1) Device must be connected with lightning protection grounding; otherwise protection level will reduce; please use above No.20 wire to connect the grounding terminal.
2) Turn the dial switch for left, the equipment can enter surveillance module after providing equipment power.

Installation step

Please check the following items before installation, if it is missing, please contact the dealer.

• 8 port PoE Ethernet Switch 1pcs
• Power adaptor 1pcs
• AC power cable 1pcs
• Accessory 1pcs
• User manual 1pcs

Please follow below the installation steps

1. Please turn off the signal power and display device power before installation, installation with power will damage the transmission equipment;
2. Use network cable connect PoE IP camera and 1～8 downlink ports of product respectively;
3. Use a network cable connect equipment uplink port and NVR or computer;
4. Connect power adapter;
5. Check if the installation is correct, equipment is in good condition, the connection is stable, then provide power for system;
6. Ensure the Ethernet equipment with power and work properly.

Specification

Troubleshoot

• Make sure the equipment is installed according to the manufactures installation guide.
• Confirm RJ45 cable order meet EIA/TIA568A or 568B standard.
• Every PoE port can provide PoE equipment maximum power less than 30W, please do not connect the PoE equipment with power over 30W.
• Replace the equipment that can not work with a proper functioning 8port PoE Ethernet switch to check if the equipment is damaged.
• Please contact your vendor if trouble still exists.

Plug Producing Method

Instruments to be used: wire crimper, network tester. Wire sequence of RJ45 plug should conform with EIA/TIA568A or 568B.

1. Please remove 2cm long the insulating layer, and bare 4 pairs UTP cable;
2. Separate the 4 pairs UTP cable and straighten them;
3. Line up the 8 pieces of cables per EIA/TIA 568A or 568B;
4. Cut off the cables to leave 1.5cm bare wire;
5. Plug 8 cables into RJ45 plug, make sure each cable is in each pin;
6. Use the wire crimper to crimp it;
7. Repeat above 5 steps to make the another end;
8. Using network tester to test the cable if it works.

Notice!
When choose RJ45 make sure if one end is EIA/TIA568A,the other end should also be EIA/TIA568A.
When choose RJ45 make sure if one end is EIA/TIA568B,the other end should also be EIA/TIA568B.